SadiMetal.com

Fittings 28 to 35

Type 28 - Two Socket Custom Cross

	Tube Reference			mm					Kg
Type	A	B	C	D	E	F	G	H
28-6	6				160				0.82
28-7	7				190				1.24
28-8	8				219				1.49

Usually used for guardrailing on a slope, between the mid-rail and an intermediate upright which is required to remain vertical.
These fittings are held in stock as blanks which are machined to individual requirements.
It is therefore, essential that when ordering, the required angle is stated.

Note: When Type 28 fittings are used in pairs (ie on stairs or ramps), they will not be handed.
The set screws on one side will therefore face inwards on the stair or ramp. For an alternative to this fitting, see Type 30.
Weights given in the table are for blank fittings.

Type 29 - 30 to 60 degree Single Socket Tee

	Tube Reference			mm					Kg
Type	A	B	C	D	E	F	G	H
29-6	6			82	64				0.44
29-7	7			93	74				0.63
29-8	8			102	68				0.97

Designed as an alternative to the Type 12 fitting, this adjustable Kee Klamp fitting is most frequently used for struts and braces.
It may be used at any selected angle between 30 and 60 degrees. As an alternative, it is possible to use Type 29 in its vertical position in place of the Type 27, using the Type 27 only where a join in the tubing occurs.

Type 30 - 30 to 45 degree Adjustable Cross

	Tube Reference			mm					Kg
Type	A	B	C	D	E	F	G	H
30-6	6				146				0.64
30-7	7				178				0.97
30-8	8				216				1.30

Designed as an alternative to the Type 28 fitting, this adjustable Kee Klamp fitting can be used for guardrailing on a slope between the mid-rail and an intermediate upright which is required to remain vertical. It may be used at any selected angle between 30 and 45 degree.

Type 31 - Pallet Flange

	Tube Reference			mm					Kg
Type	A	B	C	D	E	F	G	H
31-8	8			76	127	115			2.00

This fitting has been designed for the construction of post pallets.
Incorporates sockets for the upright and side tubes, and a locating bell for stacking pallets.

Type 35 - Side Outlet Tee

	Tube Reference			mm					Kg
Type	A	B	C	D	E	F	G	H
35-4	4			34	68				0.20
35-5	5			41	82				0.35
35-6	6			46	92				0.45
35-7	7			60	120				0.77
35-8	8			68	136				1.19
35-9	9			85	168				1.83

Most frequently used to tie uprights with horizontal tubes in three directions, all at 90 degrees to the upright.
The upright passes through the fitting.

1 , 2 , 3 , 4 , 5 , 6 , 7 , 8 , 9 , 10 , 11 , 12 , 13 , 14 , 15

Return to the Fittings Catalogue