SadiMetal.com

Fittings 21 to 27

Type 21 - Side Outlet Tee

	Tube Reference			mm					Kg
Type	A	B	C	D	E	F	G	H
21-4	4			34					0.14
21-5	5			41					0.28
21-6	6			46					0.41
21-7	7			60					0.69
21-8	8			68					0.85
21-9	9			85					1.36

Most frequently paired with Type 20 to give a 90 degree corner joint for the middle rail of guardrailing
and other rectangular structures. The upright passes through the fitting.

Type A21-26 - Split Corner Cross

	Tube Reference			mm					Kg
Type	A	B	C	D	E	F	G	H
21/26-8	8			88	60				1.07

Used for adding to and modifying existing structures. Because of this fittings design,
it can perform the same function as the Type 21 or Type 26. And because of its movable components,
it can be added to an existing an existing tubular structure.

Type 25 - Three Socket Tee

	Tube Reference			mm					Kg
Type	A	B	C	D	E	F	G	H
25-4	4			34	68				0.18
25-5	5			41	82				0.37
25-6	6			46	92				0.49
25-7	7			60	120				0.85
25-8	8			68	136				1.09
25-9	9			85	168				1.74

Most commonly used as the 90 degree joint between the top rail and an intermediate upright on guardrailing.
As there are two socket set screws in the sleeve, this Kee Klamp fitting can be used where a join is required in the horizontal tube.
As an alternative, it is possible to use a Type 10 fitting in its vertical position in place of the Type 25,
using the latter only where a join in the tubing occurs.

Type 26 - Two Socket Cross

	Tube Reference			mm					Kg
Type	A	B	C	D	E	F	G	H
26-4	4	4			68				0.13
26-5	5	5			82				0.27
26-6	6	6			92				0.40
26-7	7	7			120				0.65
26-8	8	8			136				0.85
26-87	8	7			126				0.63
26-9	9	9			168				1.46

Usually paired with Type 25 to give a 90 degree joint between the middle rail and an intermediate upright on guardrailing.
The upright passes through the fitting.

Type 27 - Three Socket Custom Tee

	Tube Reference			mm					Kg
Type	A	B	C	D	E	F	G	H
27-6	6				160				0.82
27-7	7				190				1.24
27-8	8				219				1.49

Usually used for guardrailing on a slope, between the top rail and an intermediate upright which is required to remain vertical.
These fittings are held in stock as blanks which are machined to individual requirements.
It is therefore, essential that when ordering, the required angle is stated.

Note: When Type 27 fittings are used in pairs (ie on stairs or ramps), they will not be handed.
The set screws on one side will therefore face inwards on the stair or ramp.
For an alternative to this fitting, see Type 29. Weights given in the table are for blank fittings

1 , 2 , 3 , 4 , 5 , 6 , 7 , 8 , 9 , 10 , 11 , 12 , 13 , 14 , 15

Return to the Fittings Catalogue